Windsor Five Row Pave Diamond Bangle in 18K White Gold

A Domed Five Row Pavé Face on a Solid 18K Gold Frame

The Windsor is a five row pave diamond bangle in solid 18K white gold, set with 317 round lab grown diamonds totaling 2 ct or 3 ct across the front half of a hinged oval frame. The pavé face measures 4 mm wide by 3 mm high and is domed rather than flat, so the stone coverage carries over the top edge and down both sides.

Product type

Hinged oval bangle bracelet, five row pavé

Metal

Solid 18K white gold

Stones

317 round lab grown diamonds

Total carat weight

2 ct or 3 ct

Pavé face (W x H)

4 mm x 3 mm, domed profile

Setting

Prong set pavé, five parallel rows across the front half of the frame

Back section

Plain polished solid gold, engraved Redora on the inside

Customization

Gold karat, gold color, bangle size, carat weight, pavé coverage, and stone type

It suits a wearer who wants one bracelet to carry the whole wrist instead of a stack of thin pieces. Within our bracelets collection, this is the rigid frame design built for dense, continuous stone coverage rather than a linked or station layout.

Why Five Rows Instead of a Single Line of Pavé

A single row of pavé draws a line along a bangle. Five rows across a 4 mm face fill it, so the front reads as one lit surface instead of a track of separate points. The 3 mm domed height is what makes that work: the outer rows sit on the curve rather than on the flat, which keeps stones in view when the wrist rolls sideways, not only when the arm is held palm down.

Coverage stops at the halfway point of the oval. The back half stays a plain polished rail, which keeps the total stone count and the weight in the section that is actually seen, leaves a smooth surface where the bangle rests against the underside of the wrist, and gives the hinge and closure a clean place to sit. Redora is engraved on the inside of that plain section.

How 317 Stones Are Set Across Five Rows

The frame is solid 18K gold throughout, including the hinge knuckles and the closure, not plated or filled. The stones are round brilliant lab grown diamonds, covered by a test certificate, with grading details confirmed with you before production starts. At 317 stones the melee sits in roughly the 1.2 mm to 1.4 mm range depending on whether the piece is built at 2 ct or 3 ct, and that size difference is absorbed by the stones rather than by adding or removing rows.

• ◆ All five rows are laid out and drilled against the dome before any stone goes in, because on a curved face the row lines diverge if each row is spaced off the one beside it
• ◆ Prongs are raised from the gold of the face itself, and the beads on the two outer rows are cut lower so nothing sits proud where the bangle meets a sleeve
• ◆ The 317 stones are sorted by diameter before setting, since melee this small shows any mismatch as a visible wave running along a row
• ◆ The step from the last row of pavé to the polished back section is filed and finished as one continuous curve, then the whole piece is checked for stone security and closure alignment

Sized to Your Wrist, at 2 ct or 3 ct Coverage

This bangle bracelet is built to order. The configuration shown is a starting point, not a fixed SKU. The following options can be specified before production starts.

• ◆ Bangle size: standard oval sizing, or built to a measured wrist circumference
• ◆ Gold karat: 14K or 18K, with 18K holding a richer color in the yellow and rose options
• ◆ Gold color: white gold as shown, yellow or rose gold on request
• ◆ Total carat weight: 2 ct or 3 ct, which changes stone diameter across the same five rows
• ◆ Pavé coverage: the front half as shown, or a longer run extended around the oval
• ◆ Stone type: lab grown diamond as standard, with natural diamond available on request

For fully custom designs beyond these options, start here →